Morrison Keyseater Keyseating Machine 1-1/4 inch 1981 $4,800

This keyseater will need some work to make it nice. It needs the pick feed part in one of the last pictures. Also, one of the pictures shows the clamp on the left side was welded. They may have used it this way however, I believe it could be repaired a little better. A pin and several cap screws would hold it and make a better repair than trying to weld. Also, the table is nicked up and could use some cleaning. We oiled it but that was it. It also needs the V block but this could be made pretty easily. Overall, this machine is well worth the money will make a great addition to your shop.

SPECIFICATIONS:
CUTS KEYWAYS………………………….. 1/16″ to 1-1/4″
MAXIMUM LENGTH OF CUT……………………………… 9″
LENGTH OF STROKE……………. 3″, 4-1/2″, 6″, 7-1/2″ & 9″
STROKES PER MIN………………………………….. 34
NUMBER OF FEEDS-3………………….. .002″, .004″, .006″
LARGEST DIA. CUTTER BAR………………………… 1-1/4″
DISTANCE FROM 1″ CUTTER TO COLUMN………………. 16-1/4″
MAX DISTANCE UNDER STANDARD CLAMPS…………………. 14″
DISTANCE BETWEEN CLAMPS……………………….. 25-1/2″
TABLE SIZE…………………………………. 24″ x 27″
TABLE HEIGHT FROM FLOOR…………………………… 36″
FLOOR SPACE REQUIRED………………………… 32″ x 36″
MOTOR DRIVE-GEARED MOTOR 100 RPM…………………. 2 HP
DOMESTIC SHIPPING WEIGHT…………………….. 1150 LBS.
%d bloggers like this: